Knife Blade Damascus Bar12 1/4" x 2 3/8"

Knife Blade Damascus Bar 12 1/4" x 2 3/8". This damascus steel is in the annealed (soft) state so you can cut, drill, and grind it with normal metal working tools and equipment. After working the blade it must be heat treated (hardened and tempered). It must then be etched to bring out the pattern of the Damascus. Etch in Muriatic Acid from the local hardware store. BE SURE TO FOLLOW LABEL SAFETY DIRECTIONS! Be sure the steel is clean! Etch time varies. Start with 5 minutes, then wipe and repeat until desired etch depth is reached. After etching you must neutralize the acid by rubbing the blade with a paste made from baking soda and water. Dry and oil immediately.

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: